• 2018 Super Duty Front-end Kit - Updates and Development!

  • Let's talk about new parts and solutions to common problems you want to see with a BDX logo. -T@BD
November 2019 Forum Retirement
Due to lack of extra personal time (and too much spam), I'm retiring the forum and setting it to a read-only state. No new registrations or posts will be accepted as of 11/09/19. However, all information will stay up and searchable. If you spend a few minutes searching, you'll find the answers you're looking for. We may re-open the forum next spring.
Let's talk about new parts and solutions to common problems you want to see with a BDX logo. -T@BD
 #13356  by Travis @ Buggy Depot
 Sun Mar 31, 2019 11:47 am
I'd say go ahead and swap them around. Just takes a few minutes and you're good. (y)

There's something similar going on with the front brake rotor bolts. I know that you had problems and switched over to flat head screws. But I've got my Yerf Dog 150 right here from 2012 or so (the first Yerf with front brakes ). I'm using the normal hex bolts that we include with the kit. Can you help me figure out what is going on with that? It might just be something that can be fixed with instructions, or maybe there is a legit dimension change with one of the parts that's flown under the radar recently.

I'll see if I can grab a picture, and kick off a Front Brake support thread today.
  • 1
  • 21
  • 22
  • 23
  • 24
  • 25