• Roketa GK-06 CBR 600F4i

  • Show off your builds and upgrades here!
Show off your builds and upgrades here!
 #12909  by Fink117
 Fri Oct 12, 2018 1:53 pm
Need to come up with something like this. I wish I was this good at Fabrication.
PICT0146.JPG
 #12915  by Fink117
 Sun Oct 14, 2018 10:06 am
Just seeing it mocked up made me happy. Engines going to sit higher with the transmission sitting slightly tucked in under the tail of the engine. I'm going to have to trim some off the bellhousing to make it all fit nice.
mockup.jpg
mockup2.jpg
 #13018  by Fink117
 Mon Dec 10, 2018 11:18 pm
Paging Travis looking for a gearbox for a gk06 if you have friends in Chinese places think it’s the CN250 as the CF250 has one shaft that’s longer than the other. I’m changing the build up. The GK06 is getting a predator 670cc I picked up for $200 :mrgreen: so I’m going to use that instead of the civic transmission and CBR600 going to save that for something different. I’ll post some pictures tomorrow of updates.

Fink
 #13019  by Fink117
 Tue Dec 11, 2018 3:57 pm
So here is what I've been up to. Welded the rear of the GK back together then mocked up the 600CC F4i engine and thought. I really don't want to die. the Frame is ok on this buggy but 112hp is to much for it. If I could get a Polaris 500 driveline and transmission it would be a different story. So 22 hp with my 7 year old as the passenger is much more manageable.
bdx061.jpg
bdx06.jpg
bdx06E.jpg
here is the F4i mocked up with honda civic transmission.
bdxmockup.jpg
The Civic transmission with the jackshaft setup I was going to run
bdxtrans.jpg
Attachments
bdx06.jpg
 #13200  by Fink117
 Tue Feb 19, 2019 9:30 am
So this build has morphed into many different variants. But it's nearing the finish line. The 670cc is mounted. The Stock FNR box has been rebuilt by doing cartwheels through china. I welded the rear end back together where the previous owner hacked it to bits. But we are 80% done. All i have left is Finish welding up the exhaust. Getting the torque converter installed. Figuring out what sprockets I need to run. and then Paint it up to make it look pretty to then get it absolutely filthy in mud.
bdx1.jpg
bdx2.jpg
bdx3.jpg
bdx4.jpg
 #13212  by Brandjayfab
 Sat Feb 23, 2019 6:25 pm
This is cool! Care to share any details on your fnr? model, application? How you've connected the shafts? Going with a 40 series? Thanks!
 #13235  by Fink117
 Fri Mar 01, 2019 5:19 pm
its the stock GK-06 FNR box with a modified engine output shaft to make it work.
its a 40 series converter. I Burned my hand pretty bad so I've been taking it kind of slow till it's healed up. heres where i left off.
2019-02-01 14.53.26.jpg
 #13321  by Fink117
 Sat Mar 16, 2019 11:59 am
I love this buggy. Got a new welder too. Millermatic 150 with Gas. Life is good.
  • 1
  • 3
  • 4
  • 5
  • 6
  • 7