• Buggy Depot Ball Joint Kit Install Guide

November 2019 Forum Retirement
Due to lack of extra personal time (and too much spam), I'm retiring the forum and setting it to a read-only state. No new registrations or posts will be accepted as of 11/09/19. However, all information will stay up and searchable. If you spend a few minutes searching, you'll find the answers you're looking for. We may re-open the forum next spring.
 #5  by Travis @ Buggy Depot
 Fri Jul 14, 2006 1:14 am
Buggy Depot Ball Joint Kit Install Guide

Caution:
It is very important to use loctite thread locker on the ball joint shank threads during the installation of this kit. This should be common practice on all frame and suspension parts, and especially with steering components.

Installation:

1. Locate the ball joints.
2. Use pliers to remove snap ring from ball joint.
3. Remove spindle from A-Arms.
4. Remove top from new ball joints and insert into A-Arm.
5. Place top back on to ball joint shank and tighten the supplied lock nut. If you have reinforced spindles: it is a good idea to leave the lower ball joint very loose for clearance while assembling the spindle back onto the cart.
6. Assemble the spindle back onto the cart and tighten lower locknuts on the ball joints.

Note: It is important to tighten all lock nuts as much as possible. The top and bottom ball joint holders may bend slightly when tightened, this is normal.

Note: Alignment may need to be adjusted after installation. If after installing this kit the steering becomes “touchy” at higher speeds, you need to adjust the toe-in.