• crankshaft removal

November 2019 Forum Retirement
Due to lack of extra personal time (and too much spam), I'm retiring the forum and setting it to a read-only state. No new registrations or posts will be accepted as of 11/09/19. However, all information will stay up and searchable. If you spend a few minutes searching, you'll find the answers you're looking for. We may re-open the forum next spring.
 #9886  by rpaquet
 Wed Feb 26, 2014 2:47 pm
I disassembled my Howhit 150cc motor no problems till I came to pull out the crank. I want to replace the
timing chain. But on the side were the clutch is there is a gear on the crankshaft. Not being used. How do I take that gear off so I can pull the crankshaft out and replace the timing chain. I don't know if it is pressed on or screwed on. I believe it is pressed on. Is there a special gear puller I have to get ? Any help would be appreciated. R Paquet.
 #9888  by PGH
 Fri Feb 28, 2014 12:22 am
It pressed on a slight taper. You can use a thin jaw gear puller to get it off.