On your starter solendoid relay for the baja dune 150cc model 12206458, it has a 2 sets of wires with a plug to connect to another later. Where does that plug into? My solenoid does not have a plug on in so I'm not sure if the plug was cut or what.
GY6 Knowledge - Technical Advice
Starter Solenoid
November 2019 Forum Retirement
Due to lack of extra personal time (and too much spam), I'm retiring the forum and setting it to a read-only state. No new registrations or posts will be accepted as of 11/09/19. However, all information will stay up and searchable. If you spend a few minutes searching, you'll find the answers you're looking for. We may re-open the forum next spring.
Due to lack of extra personal time (and too much spam), I'm retiring the forum and setting it to a read-only state. No new registrations or posts will be accepted as of 11/09/19. However, all information will stay up and searchable. If you spend a few minutes searching, you'll find the answers you're looking for. We may re-open the forum next spring.
I have the same buggy what I did was I cut the wires off the old relay leaving it all connected on the other end put new relay in matched the wires and spliced it together with a wirenut and elictrical tape