• Flip / Flop switch upgrade / mod

November 2019 Forum Retirement
Due to lack of extra personal time (and too much spam), I'm retiring the forum and setting it to a read-only state. No new registrations or posts will be accepted as of 11/09/19. However, all information will stay up and searchable. If you spend a few minutes searching, you'll find the answers you're looking for. We may re-open the forum next spring.
 #10528  by NCFRC
 Sat Aug 20, 2016 10:16 am
Does anybody have an upgrade wiring of the Flip/ Flop starting / ignition circuit used on a 2007 SunL 150 ?

The buggy starts very intermittently and it usually helps to cycle the on/off switch when cranking.

Yes , the stock key switch was replaced by on/ off switch with a start button.

Thanks :)
 #10529  by PGH
 Sat Aug 20, 2016 3:39 pm
The toggle enables or disables the CDI. This can be done numerous ways: Ground on kill pin, Remove CDI ground, Remove CDI power

The push button activates the starter solenoid typically by completing the ground circuit.
 #10562  by NCFRC
 Wed Sep 28, 2016 7:36 pm
A new CDI unit fixed the intermittent NO Start

I purchased one with advanced timing and no rev limiter . I liked it so much that I
ordered a 2nd one to put in my tool box :D