• Changing the carb on my crossfire 150

  • Have a technical problem? Ask here.
November 2019 Forum Retirement
Due to lack of extra personal time (and too much spam), I'm retiring the forum and setting it to a read-only state. No new registrations or posts will be accepted as of 11/09/19. However, all information will stay up and searchable. If you spend a few minutes searching, you'll find the answers you're looking for. We may re-open the forum next spring.
Have a technical problem? Ask here.
Forum rules: Help us to help you, by reading our information in this Forum thoroughly and performing the tests within to pinpoint your issue.
 #13883  by Elm2052193
 Thu Oct 03, 2019 11:32 pm
So I know I'm going to catch hell but I bought a nibbi racing carb from ebay and the throttle cable cap looks the same as the mikuni and on the site it just shows having to shave down the barrel to fit the slot on the round slide well I have the cable from the website and want to make sure I had it hooked up right ??? I put the cable and attached it to the carb but is the metal 90 deg piece supposed to sit flush up against the snout of the cap leaving the rubber grommet high up on the threads or am I supposed to fit the rubber grommet in the gap between the threads