November 2019 Forum Retirement Due to lack of extra personal time (and too much spam), I'm retiring the forum and setting it to a read-only state. No new registrations or posts will be accepted as of 11/09/19. However, all information will stay up and searchable. If you spend a few minutes searching, you'll find the answers you're looking for. We may re-open the forum next spring.
So I know I'm going to catch hell but I bought a nibbi racing carb from ebay and the throttle cable cap looks the same as the mikuni and on the site it just shows having to shave down the barrel to fit the slot on the round slide well I have the cable from the website and want to make sure I had it hooked up right ??? I put the cable and attached it to the carb but is the metal 90 deg piece supposed to sit flush up against the snout of the cap leaving the rubber grommet high up on the threads or am I supposed to fit the rubber grommet in the gap between the threads