• Engine wont run right

  • Have a technical problem? Ask here.
November 2019 Forum Retirement
Due to lack of extra personal time (and too much spam), I'm retiring the forum and setting it to a read-only state. No new registrations or posts will be accepted as of 11/09/19. However, all information will stay up and searchable. If you spend a few minutes searching, you'll find the answers you're looking for. We may re-open the forum next spring.
Have a technical problem? Ask here.
Forum rules: Help us to help you, by reading our information in this Forum thoroughly and performing the tests within to pinpoint your issue.
 #13611  by sparty117
 Fri May 24, 2019 11:03 pm
After installing the s1 exhuast from buggy depot my yerf dog gx150 struggles to start and when I does start it won't go past 1/2 throttle before bogging and turning off (runs good with stock exhuast). Would I have to change the jets on the carb or adjust something else. I have checked for compression and spark and they are all good. The carb is a DENI PD24J with stock jets and a uni air filter.