• Crossfire 150

  • Have a technical problem? Ask here.

    READ THE SECTION RULES BEFORE POSTING FOR HELP
Have a technical problem? Ask here.

READ THE SECTION RULES BEFORE POSTING FOR HELP
Forum rules: Help us to help you, by reading our information in this Forum thoroughly and performing the tests within to pinpoint your issue.
 #12949  by Chstarks
 Sun Nov 04, 2018 10:07 pm
I recently purchased the tune up kit for no spark. Changed all the parts and I am still not getting spark. I have 40 vAC at coil terminals, 1.0 amps between the terminals. However nothing through the wire to plug. Is it possible coil n wire was just bad from manufacturer, or am I just missing something.

Thanks
Chad
 #13610  by Kyrandy
 Wed May 22, 2019 11:52 pm
That's possible but make sure your plug is all the way in the boot an tight the last buggy I had was a carbide an it was bad about getting loose from bouncing around I just got a crossfire an it sets like it'll be OK the little wire that goes on the tip of the plug make sure it's in there an you hear a clucking sound when you put it on plug