• Reinforcing

  • Have a technical problem? Ask here.

    READ THE SECTION RULES BEFORE POSTING FOR HELP
Have a technical problem? Ask here.

READ THE SECTION RULES BEFORE POSTING FOR HELP
Forum rules: Help us to help you, by reading our information in this Forum thoroughly and performing the tests within to pinpoint your issue.
 #12307  by Chris486
 Fri Jun 01, 2018 5:17 pm
Have you guys done anything to this peice to make it stronger?
20180601_171411-1209x1612.jpg
 #12309  by CheethaSpeed
 Sat Jun 02, 2018 11:02 pm
Gusset weld plates are readily available but I’m not aware of a bolt on solution. Better bolts is a great start. As each piece gets stronger, the stresses just transition to a new weak link. I’ve seen several full welded bulkheads. I may or may not.... but I wonder if the bent spindle I’ve seen here wasn’t a result of no flexing anywhere else. It wasn’t a hop over a drive bump without installation error. But I also saw it burning down. Which also isn’t good for them. Idk but I haven’t heard of it being a problem either, but here again I’m not the expert.