Green Web Hosting! This site hosted by DreamHost.  
Online Store - Parts for GY6 Yerf Dog Blade Twister Hammerhead Carter Talon
The Buggy Depot Tech Center contains technical information regarding Yerf-Dog, Blade, Twister Hammerhead and many more 150cc buggies.
Buggy Depot Site Map
Buggy Depot - Off Road Buggy Forum! Click to enter!
BuggyDepot.com Tech Center - 150cc GY6 Knowledgebase! Yerf Dog, Twister Hammerhead, Tomberlin Crossfire, Carter Talon...
BuggyDepot.com Tech Center 2.0
 
Categories:
All Articles [31]
Maintenance & Troubleshooting [3]
BDX Install Guides [9]
GY6 Performance Advice [3]
Service Manuals [0]
How It Works! Writeups [5]
General GY6 Information [5]
Weaknesses & Fixes [1]
Modification Ideas [0]
BuggyDepot News
 
We're Moving! Shipping Times Not Affected, But Phone Is Down
Tuesday, June 1, 2010
BuggyDepot.com December 2009 Newsletter
Wednesday, December 9, 2009
All Crossfire 150R Parts In Stock!
Friday, October 9, 2009
Yerfer .net Content Available On BD!
Tuesday, March 24, 2009
Slow Loading Times Today 3/23/09
Monday, March 23, 2009
Please note...
 
Content is copyright © 2005 - 2010 Buggydepot.com
PROPERLY SELECTING AND INSTALLING CARBURETOR JETS [7,247 views]
 
A guide explaining how to properly select jet sizes, and installation on PD24J carburetors.
Properly Selecting And Installing Carburetor Jets
[7,247 views - 0 comments - Rating 5/5 ***** ]
Sizing at sea level:
With UNI filter 120-125
With UNI filter and low restriction exhaust 130-135
With UNI filter, low restriction exhaust, A12 cam, performance coil & CDI and NGK Iridium spark plug 135-140

Test procedure:
1. Run engine at less than half throttle a minimum of 15 minutes to close electric choke
2. On a 300' or 100 meter stretch or greater, run the engine at wide open throttle
3. While still holding the gas pedal to the floor, cut the ignition
4. Remove the spark plug and inspect end for color
a. White - Increase jet size
b. Tan/Brown - Correct jet size
c. Black - Decrease jet size
5. Clean spark plug with brass wire brush and check the gap prior to next test run

Hints:
1. Change jet size by 2 or 2.5 for fine adjustment by 5 for coarse adjustment
2. Reduce jet size by 2 or 2.5 for every 1500 ft or 500 meters of elevation
3. Stock fuel delivery may not be sufficient above a 130 main jet and may require larger diameter fuel lines and less restrictive fuel filter
4. Once main jet is selected, the air/fuel mixture screw can be adjusted for optimum idle

Thanks to PGHRUBY for this writeup!
This article has been downloaded 7,247 times
0 comments about this article:
Write a comment:
Are you a human? Type "yes":



You can rate this article without commenting...
Just select your rating and leave the comments form blank!
 
--